Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC407SP Top Searches

These results are ranked by popularity.

Error
SC370-00Description: ID sensor calibration error The reflection light output voltage of the ID sensor (Vsg_reg) is not adjusted within the target range. Upper limit: Default: 4.5 V Lower limit: Default: 3.5 V
SC874Description: An error occurred while data was being erased on HDD or NVRAM.
SC842-02Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from low power mode, the Nand-Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
SC672-12Description: Controller start up error Communication with controller was interrupted after a normal startup.
SC572-02, SC572-12Description: SC572- 02 Pressure roller thermistor (rear) cannot be reloaded SC572- 12 Pressure roller thermistor (rear) cannot be reloaded (low power) Fusing temperature failed to reach a temperature of 50 degrees C when 100 seconds passes after starting

Ricoh MPC407SP Common Errors

The most common error codes.

Error
SC370-00Description: ID sensor calibration error The reflection light output voltage of the ID sensor (Vsg_reg) is not adjusted within the target range. Upper limit: Default: 4.5 V Lower limit: Default: 3.5 V
SC874Description: An error occurred while data was being erased on HDD or NVRAM.
SC842-02Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from low power mode, the Nand-Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
SC672-12Description: Controller start up error Communication with controller was interrupted after a normal startup.
SC572-02, SC572-12Description: SC572- 02 Pressure roller thermistor (rear) cannot be reloaded SC572- 12 Pressure roller thermistor (rear) cannot be reloaded (low power) Fusing temperature failed to reach a temperature of 50 degrees C when 100 seconds passes after starting
SC370-00Description: ID sensor calibration error The reflection light output voltage of the ID sensor (Vsg_reg) is not adjusted within the target range. Upper limit: Default: 4.5 V Lower limit: Default: 3.5 V
SC874Description: An error occurred while data was being erased on HDD or NVRAM.
SC842-02Description: Number of Nand-Flash block deletions exceeded At startup, or when the machined returned from low power mode, the Nand-Flash was read and judged that the number of deleted blocks had exceeded threshold, and then SCS generated this SC code.
SC672-12Description: Controller start up error Communication with controller was interrupted after a normal startup.
SC572-02, SC572-12Description: SC572- 02 Pressure roller thermistor (rear) cannot be reloaded SC572- 12 Pressure roller thermistor (rear) cannot be reloaded (low power) Fusing temperature failed to reach a temperature of 50 degrees C when 100 seconds passes after starting