Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC3002 Top Searches

These results are ranked by popularity.

Error
492Description: High voltage power: Image transfer/ paper transfer bias output error An error signal is detected for 0.2 seconds when charging the separation, image transfer bet or paper transfer roller.
569-00Description: Pressure roller contact sensor error Pressure roller contact sensor does not detect the pressure roller position three times
841Description: EEPROM read error Mirrored data of the EEPROM is different from the original data in EEPROM.
240-03Description: LD error: M The IPU detects LDB error a few times consecutively when LDB unit turns on after LDB initialization.
720-42Description: Finisher stapler movement motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For the 2000/3000-sheet (booklet) finisher • Staple movement is not finished for a certain time. For the 1000-sheet

Ricoh MPC3002 Common Errors

The most common error codes.

Error
492Description: High voltage power: Image transfer/ paper transfer bias output error An error signal is detected for 0.2 seconds when charging the separation, image transfer bet or paper transfer roller.
569-00Description: Pressure roller contact sensor error Pressure roller contact sensor does not detect the pressure roller position three times
841Description: EEPROM read error Mirrored data of the EEPROM is different from the original data in EEPROM.
240-03Description: LD error: M The IPU detects LDB error a few times consecutively when LDB unit turns on after LDB initialization.
720-42Description: Finisher stapler movement motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For the 2000/3000-sheet (booklet) finisher • Staple movement is not finished for a certain time. For the 1000-sheet
841Description: EEPROM read error Mirrored data of the EEPROM is different from the original data in EEPROM.
492Description: High voltage power: Image transfer/ paper transfer bias output error An error signal is detected for 0.2 seconds when charging the separation, image transfer bet or paper transfer roller.
240-03Description: LD error: M The IPU detects LDB error a few times consecutively when LDB unit turns on after LDB initialization.
569-00Description: Pressure roller contact sensor error Pressure roller contact sensor does not detect the pressure roller position three times
720-42Description: Finisher stapler movement motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For the 2000/3000-sheet (booklet) finisher • Staple movement is not finished for a certain time. For the 1000-sheet