Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC2800 Top Searches

These results are ranked by popularity.

Error
230Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K].
554Description: Pressure roller fusing lamp overheat (hardware error) The pressure roller thermistor detects 250°C or more.
399Description: Drum/Development motor error: Y The machine detects a High signal from the drum/development motor for 2 seconds after the drum/development motor turned on.
740Description: Finisher corner stapler motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For 1000-sheet (booklet) finisher • The stapler motor does not switch off within the prescribed time after operating.
864Description: HDD: CRC error While reading data from the HDD or storing data in the HDD, data transmission fails.

Ricoh MPC2800 Common Errors

The most common error codes.

Error
230Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K].
554Description: Pressure roller fusing lamp overheat (hardware error) The pressure roller thermistor detects 250°C or more.
399Description: Drum/Development motor error: Y The machine detects a High signal from the drum/development motor for 2 seconds after the drum/development motor turned on.
740Description: Finisher corner stapler motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For 1000-sheet (booklet) finisher • The stapler motor does not switch off within the prescribed time after operating.
864Description: HDD: CRC error While reading data from the HDD or storing data in the HDD, data transmission fails.
230Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K].
554Description: Pressure roller fusing lamp overheat (hardware error) The pressure roller thermistor detects 250°C or more.
399Description: Drum/Development motor error: Y The machine detects a High signal from the drum/development motor for 2 seconds after the drum/development motor turned on.
740Description: Finisher corner stapler motor error The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. For 1000-sheet (booklet) finisher • The stapler motor does not switch off within the prescribed time after operating.
864Description: HDD: CRC error While reading data from the HDD or storing data in the HDD, data transmission fails.