Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MPC2504 Top Searches

These results are ranked by popularity.

Error
SC652-00Description: Remote service ID2 mismatching There was an authentication mismatch between ID2 for @Remote, the controller board, and NVRAM.
SC230-03Description: FGATE ON error: Ma The FGATE signal did not turn ON within the specified time (sec.) after the writing process of the corresponding color started.
SC564-00Description: Pressure Roller Thermistor (Center) High Temperature Detection (Hardware) Above 240 degrees C detected.
SC838-00Description: Self-diagnostic Error: Clock Generator [2701] Verify error A verify error occurred when setting data was read from the clock generator via the I2C bus.
SC867-02Description: SD card removed The SD card was removed while the machine is on.

Ricoh MPC2504 Common Errors

The most common error codes.

Error
SC652-00Description: Remote service ID2 mismatching There was an authentication mismatch between ID2 for @Remote, the controller board, and NVRAM.
SC230-03Description: FGATE ON error: Ma The FGATE signal did not turn ON within the specified time (sec.) after the writing process of the corresponding color started.
SC564-00Description: Pressure Roller Thermistor (Center) High Temperature Detection (Hardware) Above 240 degrees C detected.
SC838-00Description: Self-diagnostic Error: Clock Generator [2701] Verify error A verify error occurred when setting data was read from the clock generator via the I2C bus.
SC867-02Description: SD card removed The SD card was removed while the machine is on.
SC652-00Description: Remote service ID2 mismatching There was an authentication mismatch between ID2 for @Remote, the controller board, and NVRAM.
SC230-03Description: FGATE ON error: Ma The FGATE signal did not turn ON within the specified time (sec.) after the writing process of the corresponding color started.
SC564-00Description: Pressure Roller Thermistor (Center) High Temperature Detection (Hardware) Above 240 degrees C detected.
SC838-00Description: Self-diagnostic Error: Clock Generator [2701] Verify error A verify error occurred when setting data was read from the clock generator via the I2C bus.
SC867-02Description: SD card removed The SD card was removed while the machine is on.