Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP6503SP Top Searches

These results are ranked by popularity.

Error
SC842-00Description: Nand-Flash updating verification error CTL During remote ROM update or ROM update, the SCS detected a write error (verify error) regarding the data written to the Nand-Flash.
SC542-03Description: Fusing temperature warm-up error 3: Center thermistor The center NC sensor (thermistor) above the hot roller determined that the hot roller failed to reach the reload temperature within the prescribed time.
SC672-13Description: Controller start up error The operation panel detected that the controller is down.
SC878-00Description: TPM electronic authentication error The machine failed TPM electronic authentication. System hash registered in the TPM did not match the data on the USB flash.
SC720-52Description: Fold plate motor error (3K/2K Finisher) The fold plate did not return to its home position within the prescribed number of pulses, or it did not leave the home position within the prescribed number of pulses. The first occurrence of this err

Ricoh MP6503SP Common Errors

The most common error codes.

Error
SC842-00Description: Nand-Flash updating verification error CTL During remote ROM update or ROM update, the SCS detected a write error (verify error) regarding the data written to the Nand-Flash.
SC542-03Description: Fusing temperature warm-up error 3: Center thermistor The center NC sensor (thermistor) above the hot roller determined that the hot roller failed to reach the reload temperature within the prescribed time.
SC672-13Description: Controller start up error The operation panel detected that the controller is down.
SC878-00Description: TPM electronic authentication error The machine failed TPM electronic authentication. System hash registered in the TPM did not match the data on the USB flash.
SC720-52Description: Fold plate motor error (3K/2K Finisher) The fold plate did not return to its home position within the prescribed number of pulses, or it did not leave the home position within the prescribed number of pulses. The first occurrence of this err
SC672-13Description: Controller start up error The operation panel detected that the controller is down.
SC720-52Description: Fold plate motor error (3K/2K Finisher) The fold plate did not return to its home position within the prescribed number of pulses, or it did not leave the home position within the prescribed number of pulses. The first occurrence of this err
SC878-00Description: TPM electronic authentication error The machine failed TPM electronic authentication. System hash registered in the TPM did not match the data on the USB flash.
SC722-80Description: Finisher staple trimming hopper full (Finisher D610) The staple waste hopper is full of cut staples.
SC505-04Description: LCIT error: Paper overload error At initialization the machine detected both the lift sensor and lower limit sensor ON.