These results are ranked by popularity.
Error | |
---|---|
SC370-00 | Description: ID Sensor Calibration Error Regular reflection optical output voltage of the ID sensor: Vsg_reg cannot be adjusted to within target range. Upper limit (SP3-320-013: initial value 4.5V) Lower limit (SP3-320-014: initial value 3.5V) |
SC720-42 | Description: Edge Stapler Displacement Motor Error (2K/3K sheet finisher) • Motor driver detects an error (short-circuit/ overheating) (1st time, SC). • During movement to home, the home position could not be detected within a predetermined pulse (p0 pul |
SC828-00 | Description: Self-diagnostic error: ROM [xxxx]: Detailed error code |
SC721-80 | Description: Folding Transport Motor Error (1K sheet finisher) • Motor driver detects an error (short-circuit or overheating) (1st time is SC) |
SC868-02 | Description: SD card access error The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd1) |
The most common error codes.
Error | |
---|---|
SC370-00 | Description: ID Sensor Calibration Error Regular reflection optical output voltage of the ID sensor: Vsg_reg cannot be adjusted to within target range. Upper limit (SP3-320-013: initial value 4.5V) Lower limit (SP3-320-014: initial value 3.5V) |
SC720-42 | Description: Edge Stapler Displacement Motor Error (2K/3K sheet finisher) • Motor driver detects an error (short-circuit/ overheating) (1st time, SC). • During movement to home, the home position could not be detected within a predetermined pulse (p0 pul |
SC828-00 | Description: Self-diagnostic error: ROM [xxxx]: Detailed error code |
SC721-80 | Description: Folding Transport Motor Error (1K sheet finisher) • Motor driver detects an error (short-circuit or overheating) (1st time is SC) |
SC868-02 | Description: SD card access error The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd1) |
SC370-00 | Description: ID Sensor Calibration Error Regular reflection optical output voltage of the ID sensor: Vsg_reg cannot be adjusted to within target range. Upper limit (SP3-320-013: initial value 4.5V) Lower limit (SP3-320-014: initial value 3.5V) |
SC720-42 | Description: Edge Stapler Displacement Motor Error (2K/3K sheet finisher) • Motor driver detects an error (short-circuit/ overheating) (1st time, SC). • During movement to home, the home position could not be detected within a predetermined pulse (p0 pul |
SC828-00 | Description: Self-diagnostic error: ROM [xxxx]: Detailed error code |
SC721-80 | Description: Folding Transport Motor Error (1K sheet finisher) • Motor driver detects an error (short-circuit or overheating) (1st time is SC) |
SC868-02 | Description: SD card access error The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd1) |