Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP6002 Top Searches

These results are ranked by popularity.

Error
722-80Description: Finisher staple trimming hopper full (D610) The staple waste hopper is full of cut staples.
838Description: Self-diagnostic Error: Clock Generator A verify error occurred when setting data was read from the clock generator via the I2C bus.
495-00Description: Toner recycling unit error Encoder pulse does not change for 3 s after the main motor switches on.
912Description: External Controller Error 3
202Description: Polygon mirror motor error 1: Timeout at ON The polygon mirror motor unit did not enter "Ready" status within 20 sec. after the motor was turned on,

Ricoh MP6002 Common Errors

The most common error codes.

Error
722-80Description: Finisher staple trimming hopper full (D610) The staple waste hopper is full of cut staples.
838Description: Self-diagnostic Error: Clock Generator A verify error occurred when setting data was read from the clock generator via the I2C bus.
495-00Description: Toner recycling unit error Encoder pulse does not change for 3 s after the main motor switches on.
912Description: External Controller Error 3
202Description: Polygon mirror motor error 1: Timeout at ON The polygon mirror motor unit did not enter "Ready" status within 20 sec. after the motor was turned on,
722-80Description: Finisher staple trimming hopper full (D610) The staple waste hopper is full of cut staples.
912Description: External Controller Error 3
495-00Description: Toner recycling unit error Encoder pulse does not change for 3 s after the main motor switches on.
202Description: Polygon mirror motor error 1: Timeout at ON The polygon mirror motor unit did not enter "Ready" status within 20 sec. after the motor was turned on,
720-44Description: Finisher corner stapler motor error (D611/D612) The stapler motor does not switch off within the prescribed time after operating. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.