Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP6000SP Top Searches

These results are ranked by popularity.

Error
781Description: Z-Fold lower stopper motor The lower stopper motor does not attain the prescribed speed within the specified time.
701Description: ADF bottom plate motor error • Bottom plate position sensor does not detect the plate after the bottom plate lift motor switches on to lift the plate. • Bottom plate HP sensor does not detect the plate after the bottom plate motor reverse
741Description: Finisher corner stapler rotation motor error B246 The stapler does not return to its home position within the specified time after stapling. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
507Description: LCT feed motor malfunction One of the following conditions is detected: • The LD signal from the feed motor is detected abnormal for 50 ms after the motor switches on. • At power on, the motor is detected loose or disconnected
310Description: Potential sensor calibration error 1 During drum potential sensor calibration, the drum potential sensor output voltage does not meet specification when test voltages (– 100V, –800V) are applied to the drum.

Ricoh MP6000SP Common Errors

The most common error codes.

Error
781Description: Z-Fold lower stopper motor The lower stopper motor does not attain the prescribed speed within the specified time.
701Description: ADF bottom plate motor error • Bottom plate position sensor does not detect the plate after the bottom plate lift motor switches on to lift the plate. • Bottom plate HP sensor does not detect the plate after the bottom plate motor reverse
741Description: Finisher corner stapler rotation motor error B246 The stapler does not return to its home position within the specified time after stapling. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
507Description: LCT feed motor malfunction One of the following conditions is detected: • The LD signal from the feed motor is detected abnormal for 50 ms after the motor switches on. • At power on, the motor is detected loose or disconnected
310Description: Potential sensor calibration error 1 During drum potential sensor calibration, the drum potential sensor output voltage does not meet specification when test voltages (– 100V, –800V) are applied to the drum.
781Description: Z-Fold lower stopper motor The lower stopper motor does not attain the prescribed speed within the specified time.
701Description: ADF bottom plate motor error • Bottom plate position sensor does not detect the plate after the bottom plate lift motor switches on to lift the plate. • Bottom plate HP sensor does not detect the plate after the bottom plate motor reverse
741Description: Finisher corner stapler rotation motor error B246 The stapler does not return to its home position within the specified time after stapling. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
507Description: LCT feed motor malfunction One of the following conditions is detected: • The LD signal from the feed motor is detected abnormal for 50 ms after the motor switches on. • At power on, the motor is detected loose or disconnected
310Description: Potential sensor calibration error 1 During drum potential sensor calibration, the drum potential sensor output voltage does not meet specification when test voltages (– 100V, –800V) are applied to the drum.