Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP501SPF Top Searches

These results are ranked by popularity.

Error
SC687-00Description: PER Not Received Error RAPI-PER command was not received from the controller within the specified time (120 sec.) after RAPI-PES (preparation request for image transmission) is issued.
SC503-01Description: Paper Feed Tray Lift Motor Error (Tray 3) After the paper feed tray 3 is set, paper feed tray lift sensor does not turn on within 10 seconds. This SC is issued if a problem is detected four times consecutively.
SC865-02 ... SC865-23Description: HDD access error During HDD operation, the HDD returned an error.
SC553-00Description: Fusing Thermistor (End) High Temperature • The fusing thermistor (end) detects the temperature that exceeds 245 degrees C. • The fusing thermistor (end) detects the temperature that exceeds 195 degrees C in a heater-off state after the fusin
SC543-00Description: Fusing Thermistor (Center) High Temperature • The fusing thermistor (center) detects the temperature that exceeds 245 degrees C. • The fusing thermistor (center) detects the temperature that exceeds 195 degrees C in a heater-off state after

Ricoh MP501SPF Common Errors

The most common error codes.

Error
SC687-00Description: PER Not Received Error RAPI-PER command was not received from the controller within the specified time (120 sec.) after RAPI-PES (preparation request for image transmission) is issued.
SC503-01Description: Paper Feed Tray Lift Motor Error (Tray 3) After the paper feed tray 3 is set, paper feed tray lift sensor does not turn on within 10 seconds. This SC is issued if a problem is detected four times consecutively.
SC865-02 ... SC865-23Description: HDD access error During HDD operation, the HDD returned an error.
SC553-00Description: Fusing Thermistor (End) High Temperature • The fusing thermistor (end) detects the temperature that exceeds 245 degrees C. • The fusing thermistor (end) detects the temperature that exceeds 195 degrees C in a heater-off state after the fusin
SC543-00Description: Fusing Thermistor (Center) High Temperature • The fusing thermistor (center) detects the temperature that exceeds 245 degrees C. • The fusing thermistor (center) detects the temperature that exceeds 195 degrees C in a heater-off state after
SC687-00Description: PER Not Received Error RAPI-PER command was not received from the controller within the specified time (120 sec.) after RAPI-PES (preparation request for image transmission) is issued.
SC503-01Description: Paper Feed Tray Lift Motor Error (Tray 3) After the paper feed tray 3 is set, paper feed tray lift sensor does not turn on within 10 seconds. This SC is issued if a problem is detected four times consecutively.
SC865-02 ... SC865-23Description: HDD access error During HDD operation, the HDD returned an error.
SC553-00Description: Fusing Thermistor (End) High Temperature • The fusing thermistor (end) detects the temperature that exceeds 245 degrees C. • The fusing thermistor (end) detects the temperature that exceeds 195 degrees C in a heater-off state after the fusin
SC543-00Description: Fusing Thermistor (Center) High Temperature • The fusing thermistor (center) detects the temperature that exceeds 245 degrees C. • The fusing thermistor (center) detects the temperature that exceeds 195 degrees C in a heater-off state after