Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP3350 Top Searches

These results are ranked by popularity.

Error
839Description: USB flash error This is a self-diagnostic error. The device ID of the on-board USB flash ROM was not recognized.
350Description: ID sensor calibration – Error 1 One of the following conditions occurred when the ID sensor pattern was calibrated during printing: Vsp > 2.5V Vsg < 2.5V Vsp = 0V Vsg = 0V
559Description: Consecutive fusing unit paper jams Three consecutive paper jams occurred in the fusing unit. The paper jam counter for the fusing unit reaches 3 times. The paper jam counter clears after the paper feeds correctly. Note: This SC is issued onl
687Description: Memory address (PER) command error The BCU did not receive a memory address command from the controller with the prescribed time once the paper reached the registration sensor.
101-1Description: Exposure lamp error 1 The standard white level could not be set properly when scanning the white plate during automatic white level adjustment.

Ricoh MP3350 Common Errors

The most common error codes.

Error
839Description: USB flash error This is a self-diagnostic error. The device ID of the on-board USB flash ROM was not recognized.
350Description: ID sensor calibration – Error 1 One of the following conditions occurred when the ID sensor pattern was calibrated during printing: Vsp > 2.5V Vsg < 2.5V Vsp = 0V Vsg = 0V
559Description: Consecutive fusing unit paper jams Three consecutive paper jams occurred in the fusing unit. The paper jam counter for the fusing unit reaches 3 times. The paper jam counter clears after the paper feeds correctly. Note: This SC is issued onl
687Description: Memory address (PER) command error The BCU did not receive a memory address command from the controller with the prescribed time once the paper reached the registration sensor.
101-1Description: Exposure lamp error 1 The standard white level could not be set properly when scanning the white plate during automatic white level adjustment.
839Description: USB flash error This is a self-diagnostic error. The device ID of the on-board USB flash ROM was not recognized.
350Description: ID sensor calibration – Error 1 One of the following conditions occurred when the ID sensor pattern was calibrated during printing: Vsp > 2.5V Vsg < 2.5V Vsp = 0V Vsg = 0V
559Description: Consecutive fusing unit paper jams Three consecutive paper jams occurred in the fusing unit. The paper jam counter for the fusing unit reaches 3 times. The paper jam counter clears after the paper feeds correctly. Note: This SC is issued onl
687Description: Memory address (PER) command error The BCU did not receive a memory address command from the controller with the prescribed time once the paper reached the registration sensor.
101-1Description: Exposure lamp error 1 The standard white level could not be set properly when scanning the white plate during automatic white level adjustment.