Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP2580 Top Searches

These results are ranked by popularity.

Error
792Description: Finisher error The machine does not recognize the finisher, but recognizes the bridge unit.
490Description: Toner supply motor: Excess current error The machine detects the current of 1A or more supplied to the toner supply motor for 0.2 seconds.
552Description: Fusing temperature warm-up error (rear) The fusing temperature rises less than 7 degrees in 2 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 25 or 35 seconds.
545Description: Fusing lamp overheat error (center) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 12 consecutive seconds.
01Description: Transfer roller leak error 1 A current leak signal for the transfer roller is detected. A current feedback signal for the transfer roller is not detected.

Ricoh MP2580 Common Errors

The most common error codes.

Error
792Description: Finisher error The machine does not recognize the finisher, but recognizes the bridge unit.
490Description: Toner supply motor: Excess current error The machine detects the current of 1A or more supplied to the toner supply motor for 0.2 seconds.
552Description: Fusing temperature warm-up error (rear) The fusing temperature rises less than 7 degrees in 2 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 25 or 35 seconds.
545Description: Fusing lamp overheat error (center) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 12 consecutive seconds.
01Description: Transfer roller leak error 1 A current leak signal for the transfer roller is detected. A current feedback signal for the transfer roller is not detected.
792Description: Finisher error The machine does not recognize the finisher, but recognizes the bridge unit.
490Description: Toner supply motor: Excess current error The machine detects the current of 1A or more supplied to the toner supply motor for 0.2 seconds.
552Description: Fusing temperature warm-up error (rear) The fusing temperature rises less than 7 degrees in 2 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 25 or 35 seconds.
545Description: Fusing lamp overheat error (center) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 12 consecutive seconds.
01Description: Transfer roller leak error 1 A current leak signal for the transfer roller is detected. A current feedback signal for the transfer roller is not detected.