Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP2510 Top Searches

These results are ranked by popularity.

Error
986Description: Software write parameter setting error An unstable area at the storage destination in the settings table is set at NULL for the parameter received by the write module.
612Description: Communication command error between SBCU and ADF The SBCU sends a command to the ADF main board that it cannot execute.
351Description: ID sensor calibration - Error 2 The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: • Vsg = 5V • PWM = 0 (LED current drop)
840Description: EEPROM error 1 During input/output with the EEPROM on the controller board, one of the following errors occurred: • A read error occurred and continued after 3 retries. • A write error occurred.
401Description: Transfer roller leak error 1 A transfer roller current leak signal is detected. The current feedback signal for the transfer roller is not detected within the correct time.

Ricoh MP2510 Common Errors

The most common error codes.

Error
986Description: Software write parameter setting error An unstable area at the storage destination in the settings table is set at NULL for the parameter received by the write module.
612Description: Communication command error between SBCU and ADF The SBCU sends a command to the ADF main board that it cannot execute.
351Description: ID sensor calibration - Error 2 The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: • Vsg = 5V • PWM = 0 (LED current drop)
840Description: EEPROM error 1 During input/output with the EEPROM on the controller board, one of the following errors occurred: • A read error occurred and continued after 3 retries. • A write error occurred.
401Description: Transfer roller leak error 1 A transfer roller current leak signal is detected. The current feedback signal for the transfer roller is not detected within the correct time.
612Description: Communication command error between SBCU and ADF The SBCU sends a command to the ADF main board that it cannot execute.
986Description: Software write parameter setting error An unstable area at the storage destination in the settings table is set at NULL for the parameter received by the write module.
840Description: EEPROM error 1 During input/output with the EEPROM on the controller board, one of the following errors occurred: • A read error occurred and continued after 3 retries. • A write error occurred.
351Description: ID sensor calibration - Error 2 The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: • Vsg = 5V • PWM = 0 (LED current drop)
862Description: HDD error 2 Maximum number of bad sectors detected on HD. Up to 101 bad sectors have appeared in the area on the hard disk where image data is archived, and the hard disk may require replacement.