Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP2352SP Top Searches

These results are ranked by popularity.

Error
862Description: Bad sector number error The number of bad sectors in the HDD (image data area) goes over 101
504Description: Tray 4 error (3 Tray Paper Feed Unit) This SC is generated if the following condition occurs 3 consecutive times. • When the tray lowers, the tray lift sensor does not go off within 1.5 sec.
674Description: Transmission error in controller board Video transmission error is detected in the controller board.
798-03Description: Rear fence motor error (D585) The machine does not detect a correct signal from the rear jogger fence HP sensor while the rear jogger motor is operating. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
202Description: Polygon motor error 1: ON timeout The polygon mirror motor did not reach the targeted operating speed within 10 sec. after turning on or changing speed

Ricoh MP2352SP Common Errors

The most common error codes.

Error
862Description: Bad sector number error The number of bad sectors in the HDD (image data area) goes over 101
504Description: Tray 4 error (3 Tray Paper Feed Unit) This SC is generated if the following condition occurs 3 consecutive times. • When the tray lowers, the tray lift sensor does not go off within 1.5 sec.
674Description: Transmission error in controller board Video transmission error is detected in the controller board.
798-03Description: Rear fence motor error (D585) The machine does not detect a correct signal from the rear jogger fence HP sensor while the rear jogger motor is operating. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
202Description: Polygon motor error 1: ON timeout The polygon mirror motor did not reach the targeted operating speed within 10 sec. after turning on or changing speed
862Description: Bad sector number error The number of bad sectors in the HDD (image data area) goes over 101
504Description: Tray 4 error (3 Tray Paper Feed Unit) This SC is generated if the following condition occurs 3 consecutive times. • When the tray lowers, the tray lift sensor does not go off within 1.5 sec.
674Description: Transmission error in controller board Video transmission error is detected in the controller board.
798-03Description: Rear fence motor error (D585) The machine does not detect a correct signal from the rear jogger fence HP sensor while the rear jogger motor is operating. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
202Description: Polygon motor error 1: ON timeout The polygon mirror motor did not reach the targeted operating speed within 10 sec. after turning on or changing speed