Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP1801 Top Searches

These results are ranked by popularity.

Error
321Description: No laser writing signal (F-GATE) error The laser-writing signal (F-GATE) fails to turn Low after the laser crosses 5 mm on the drum surface from the laser writing start position.
544Description: Fusing overheat error (center) 2 The fusing temperature is over 250°C for 1 second (detected by the fusing temperature monitor circuit).
101Description: Exposure Lamp Error The standard white level was not detected properly when scanning the white plate.
322Description: Laser synchronization error The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
545Description: Fusing lamp overheat error (center) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 15 consecutive seconds.

Ricoh MP1801 Common Errors

The most common error codes.

Error
321Description: No laser writing signal (F-GATE) error The laser-writing signal (F-GATE) fails to turn Low after the laser crosses 5 mm on the drum surface from the laser writing start position.
544Description: Fusing overheat error (center) 2 The fusing temperature is over 250°C for 1 second (detected by the fusing temperature monitor circuit).
101Description: Exposure Lamp Error The standard white level was not detected properly when scanning the white plate.
322Description: Laser synchronization error The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
545Description: Fusing lamp overheat error (center) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 15 consecutive seconds.
321Description: No laser writing signal (F-GATE) error The laser-writing signal (F-GATE) fails to turn Low after the laser crosses 5 mm on the drum surface from the laser writing start position.
544Description: Fusing overheat error (center) 2 The fusing temperature is over 250°C for 1 second (detected by the fusing temperature monitor circuit).
101Description: Exposure Lamp Error The standard white level was not detected properly when scanning the white plate.
322Description: Laser synchronization error The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
545Description: Fusing lamp overheat error (center) After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 15 consecutive seconds.