Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh IMC6000 Top Searches

These results are ranked by popularity.

Error
SC727-01Description: Internal Multi-Fold Unit FD3010 Error Connection Error to Downstream Unit Communication error has occurred with the serial interface of the downstream unit. This is displayed as an SC code from its initial detection.
SC843-02Description: eMMC rewrite frequency exceeded the threshold (Smart Operation Panel) At startup, or when the machined returned from energy saving mode, the eMMC was read and judged that the number of rewrote blocks had exceeded the threshold.
SC868Description: SD card access error SC868-00 The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd0) SC868-01 The SD controller returned an error during operation. (An error occurred at the mount point of /m
SC911-24Description: CPU0 Temperature Alert
SC995-01Description: CPM setting error 1 Comparison of machine serial number (11 digits) and machine identification code. Details: • Machine serial number cannot be identified because of BICU replacement or malfunctioning. • Machine serial number cannot be iden

Ricoh IMC6000 Common Errors

The most common error codes.

Error
SC727-01Description: Internal Multi-Fold Unit FD3010 Error Connection Error to Downstream Unit Communication error has occurred with the serial interface of the downstream unit. This is displayed as an SC code from its initial detection.
SC843-02Description: eMMC rewrite frequency exceeded the threshold (Smart Operation Panel) At startup, or when the machined returned from energy saving mode, the eMMC was read and judged that the number of rewrote blocks had exceeded the threshold.
SC868Description: SD card access error SC868-00 The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd0) SC868-01 The SD controller returned an error during operation. (An error occurred at the mount point of /m
SC911-24Description: CPU0 Temperature Alert
SC995-01Description: CPM setting error 1 Comparison of machine serial number (11 digits) and machine identification code. Details: • Machine serial number cannot be identified because of BICU replacement or malfunctioning. • Machine serial number cannot be iden
SC561-01, SC561-05Description: SC561-01 Pressure Roller Thermistor (Center) Disconnection SC561-05 Pressure Roller Thermistor (Center) Disconnection (Low Power) In Machine Condition A, after turning the fusing lamp on, the pressure roller thermistor (center) (TH3) has det
SC650-13Description: Remote Service Modem Communication Error (RC Gate Type M was installed but modem is not present (detected during operation)) • An error related to communication (dialup connection, modem board etc.) using the RC Gate Type M was detected or a
SC670-03Description: IPU start up error when the machine boots up VDET_EPCI signal was not asserted when the machine was turned on.
SC720-70Description: Booklet Finisher SR3290/Finisher SR3280 Error Folding Transport Motor Error • Motor controller detects an error (overload) (Jam notification for 1st to 4th times, SC notification for 5th time) • During descent, the paper surface sensor still
SC722-06Description: Finisher SR3260 Error Access error to NVRAM Error occurs when accessing NV memory.