Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh IMC2500 Top Searches

These results are ranked by popularity.

Error
SC552-02Description: Thermopile (Edge) Does Not Reload In Machine Condition B, after turning the fusing lamp (edge) on, the thermopile (edge) (TH2) has failed to reach 65°C in 14 seconds. Machine Condition B refers to any of the following conditions: • In Warm-u
SC504-21Description: 4th Tray Lift Error (Two-tray paper feed unit) • Lift motor ascent error detection During tray initialization (upper limit not detected/lower limit detection), the tray base plate is raised to check the tray base plate position, but the uppe
SC890-01Description: PaaS* function: Tampering detection PaaS data in NVRAM and on USB flash drive do not match at startup.
SC724-31Description: Internal Finisher SR3250 Error Jogger Front Motor Error • When front jogger motor is driven for specified time (msec.) when front jogger HP sensor is ON, the HP sensor does not switch OFF (Jam notification for 1st to 4th times, SC notificati
SC721-80Description: Booklet Finisher SR3270 Error Folding Transport Motor Error • Motor driver detects an error (short-circuit or overheating) (1st time is SC)

Ricoh IMC2500 Common Errors

The most common error codes.

Error
SC552-02Description: Thermopile (Edge) Does Not Reload In Machine Condition B, after turning the fusing lamp (edge) on, the thermopile (edge) (TH2) has failed to reach 65°C in 14 seconds. Machine Condition B refers to any of the following conditions: • In Warm-u
SC504-21Description: 4th Tray Lift Error (Two-tray paper feed unit) • Lift motor ascent error detection During tray initialization (upper limit not detected/lower limit detection), the tray base plate is raised to check the tray base plate position, but the uppe
SC890-01Description: PaaS* function: Tampering detection PaaS data in NVRAM and on USB flash drive do not match at startup.
SC724-31Description: Internal Finisher SR3250 Error Jogger Front Motor Error • When front jogger motor is driven for specified time (msec.) when front jogger HP sensor is ON, the HP sensor does not switch OFF (Jam notification for 1st to 4th times, SC notificati
SC721-80Description: Booklet Finisher SR3270 Error Folding Transport Motor Error • Motor driver detects an error (short-circuit or overheating) (1st time is SC)
SC720-06Description: Booklet Finisher SR3290/Finisher SR3280 Error Access error to NVRAM Error occurs when accessing NV memory.
SC667-10Description: Slave1 Device Mode Setting Error The machine detects the Slave1 mode error when starting up, or recovery from energy saving mode.
SC552-02Description: Thermopile (Edge) Does Not Reload In Machine Condition B, after turning the fusing lamp (edge) on, the thermopile (edge) (TH2) has failed to reach 65°C in 14 seconds. Machine Condition B refers to any of the following conditions: • In Warm-u
SC864-01Description: HDD data CRC error During HDD operation, the HDD cannot respond to a CRC error query. Data transfer did not execute normally while data was being written to the HDD.
SC721-80Description: Booklet Finisher SR3270 Error Folding Transport Motor Error • Motor driver detects an error (short-circuit or overheating) (1st time is SC)