Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh DX2330 Top Searches

These results are ranked by popularity.

Error
E-18Description: Drum Overheat The temperature of the drum is greater than 54C when the Start key is pressed.
E-00Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-21Description: Paper Exit Timing Sensor error The paper exit timing sensor does not activate before the master eject position sensor activates.
E-01Description: Cutter error The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.
E-22Description: 2nd Feed Timing Sensor error The 2nd feed timing sensor does not activate before the paper exit timing sensor activates.

Ricoh DX2330 Common Errors

The most common error codes.

Error
E-18Description: Drum Overheat The temperature of the drum is greater than 54C when the Start key is pressed.
E-00Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-21Description: Paper Exit Timing Sensor error The paper exit timing sensor does not activate before the master eject position sensor activates.
E-01Description: Cutter error The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.
E-22Description: 2nd Feed Timing Sensor error The 2nd feed timing sensor does not activate before the paper exit timing sensor activates.
E-18Description: Drum Overheat The temperature of the drum is greater than 54C when the Start key is pressed.
E-00Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-21Description: Paper Exit Timing Sensor error The paper exit timing sensor does not activate before the master eject position sensor activates.
E-01Description: Cutter error The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.
E-22Description: 2nd Feed Timing Sensor error The 2nd feed timing sensor does not activate before the paper exit timing sensor activates.