Ricoh AP900 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh AP900 Top Searches

These results are ranked by popularity.

Error
964Description: Printer ready error The print ready signal is not generated for more than 17 seconds after the IPU received the print start signal.
726Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray.
744Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
336Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off.
822Description: Self-diagnostic error 3: HDD

Ricoh AP900 Common Errors

The most common error codes.

Error
964Description: Printer ready error The print ready signal is not generated for more than 17 seconds after the IPU received the print start signal.
726Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray.
744Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
336Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off.
822Description: Self-diagnostic error 3: HDD
822Description: Self-diagnostic error 3: HDD
964Description: Printer ready error The print ready signal is not generated for more than 17 seconds after the IPU received the print start signal.
744Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
336Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off.
545Description: Fusing lamp overheat error 2 After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating.