Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh AP4510 Top Searches

These results are ranked by popularity.

Error
405Description: Transfer belt position abnormal The transfer belt does not separate from the drum during ID sensor pattern checking.
729Description: Finisher punch motor error After the punch motor turns on, the punch H.P. sensor does not activate within the specified time.
302Description: Charge roller current leak A charge roller current leak signal was detected.
900Description: Electronic total count error • The value of the total count has already exceeded its limit (9,999,999) • During counting, a defect was detected at the mechanical counter.
966Description: No ready signal from the polygon motor. At the start of printing, no ready signal is received for the polygon motor from the LD unit.

Ricoh AP4510 Common Errors

The most common error codes.

Error
405Description: Transfer belt position abnormal The transfer belt does not separate from the drum during ID sensor pattern checking.
729Description: Finisher punch motor error After the punch motor turns on, the punch H.P. sensor does not activate within the specified time.
302Description: Charge roller current leak A charge roller current leak signal was detected.
900Description: Electronic total count error • The value of the total count has already exceeded its limit (9,999,999) • During counting, a defect was detected at the mechanical counter.
966Description: No ready signal from the polygon motor. At the start of printing, no ready signal is received for the polygon motor from the LD unit.
405Description: Transfer belt position abnormal The transfer belt does not separate from the drum during ID sensor pattern checking.
729Description: Finisher punch motor error After the punch motor turns on, the punch H.P. sensor does not activate within the specified time.
302Description: Charge roller current leak A charge roller current leak signal was detected.
900Description: Electronic total count error • The value of the total count has already exceeded its limit (9,999,999) • During counting, a defect was detected at the mechanical counter.
966Description: No ready signal from the polygon motor. At the start of printing, no ready signal is received for the polygon motor from the LD unit.