Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh AP3850C Top Searches

These results are ranked by popularity.

Error
SC730Description: Finisher stapler motor error The stapler home position is not detected within a specified time after the staple motor turns on.
SC460-002Description: Thermistor 1 error (short circuit) When the temperature detected by the thermistor 1, which is at the left (fusing unit) side of the laser optics unit, is higher than 70°C for 10 seconds consecutively, the BCU determines that the circuit is
SC998Description: Application start error No applications start within 60 seconds after the power is turned on.
SC551Description: Pressure roller thermistor error The measured pressure roller temperature does not reach 7°C for 30 seconds.
SC260Description: LD HP sensor not switched on (for K only) During homing, it takes more than five seconds to switch the HP sensor on (the sensor actuator does not cover the sensor).

Ricoh AP3850C Common Errors

The most common error codes.

Error
SC730Description: Finisher stapler motor error The stapler home position is not detected within a specified time after the staple motor turns on.
SC460-002Description: Thermistor 1 error (short circuit) When the temperature detected by the thermistor 1, which is at the left (fusing unit) side of the laser optics unit, is higher than 70°C for 10 seconds consecutively, the BCU determines that the circuit is
SC998Description: Application start error No applications start within 60 seconds after the power is turned on.
SC551Description: Pressure roller thermistor error The measured pressure roller temperature does not reach 7°C for 30 seconds.
SC260Description: LD HP sensor not switched on (for K only) During homing, it takes more than five seconds to switch the HP sensor on (the sensor actuator does not cover the sensor).
SC730Description: Finisher stapler motor error The stapler home position is not detected within a specified time after the staple motor turns on.
SC460-002Description: Thermistor 1 error (short circuit) When the temperature detected by the thermistor 1, which is at the left (fusing unit) side of the laser optics unit, is higher than 70°C for 10 seconds consecutively, the BCU determines that the circuit is
SC998Description: Application start error No applications start within 60 seconds after the power is turned on.
SC551Description: Pressure roller thermistor error The measured pressure roller temperature does not reach 7°C for 30 seconds.
SC260Description: LD HP sensor not switched on (for K only) During homing, it takes more than five seconds to switch the HP sensor on (the sensor actuator does not cover the sensor).