Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio Color 6513 Top Searches

These results are ranked by popularity.

Error
SC401Description: Locked image transfer belt motor - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal was sent. • The feedback signal goes out of range for 2 seconds while the trigger signal is
SC604Description: IDU communication error - Timing & Condition - No response is received from the IDU within 200 ms after the scanner IP board sends a command signal. (this must occur three times before the error is displayed).
SC742Description: LCT: Tray lift error - Timing & Condition - • The upper limit sensor does not activate within 18 seconds of the lift motor being turned on (in UP direction), when the main switch is turned on, or when the LCT cover is closed. • The lower lim
SC193Description: IDU error - Timing - When the main switch is turned on - Condition - The IDU runs a diagnostic at power-on. Any hardware errors are detected during the diagnostics.
SC504Description: - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate begins to lower. • The upper limit sensor stays HIGH 10 seconds after

Ricoh Aficio Color 6513 Common Errors

The most common error codes.

Error
SC401Description: Locked image transfer belt motor - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal was sent. • The feedback signal goes out of range for 2 seconds while the trigger signal is
SC604Description: IDU communication error - Timing & Condition - No response is received from the IDU within 200 ms after the scanner IP board sends a command signal. (this must occur three times before the error is displayed).
SC742Description: LCT: Tray lift error - Timing & Condition - • The upper limit sensor does not activate within 18 seconds of the lift motor being turned on (in UP direction), when the main switch is turned on, or when the LCT cover is closed. • The lower lim
SC193Description: IDU error - Timing - When the main switch is turned on - Condition - The IDU runs a diagnostic at power-on. Any hardware errors are detected during the diagnostics.
SC504Description: - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate begins to lower. • The upper limit sensor stays HIGH 10 seconds after
SC401Description: Locked image transfer belt motor - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal was sent. • The feedback signal goes out of range for 2 seconds while the trigger signal is
SC604Description: IDU communication error - Timing & Condition - No response is received from the IDU within 200 ms after the scanner IP board sends a command signal. (this must occur three times before the error is displayed).
SC742Description: LCT: Tray lift error - Timing & Condition - • The upper limit sensor does not activate within 18 seconds of the lift motor being turned on (in UP direction), when the main switch is turned on, or when the LCT cover is closed. • The lower lim
SC193Description: IDU error - Timing - When the main switch is turned on - Condition - The IDU runs a diagnostic at power-on. Any hardware errors are detected during the diagnostics.
SC504Description: - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate begins to lower. • The upper limit sensor stays HIGH 10 seconds after