Error |
---|
These results are ranked by popularity.
Error | |
---|---|
SC401 | Description: Image transfer belt motor lock - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal is sent. • The feedback signal becomes out of range for 2 seconds while the trigger signal is |
SC604 | Description: IDU communication error - Timing & Condition - No response is received from the IDU within 200 ms after the scanner IP board sends a command signal and this error is detected 3 times in total. |
SC742 | Description: LCT: Tray lift error - Timing & Condition - • The upper limit sensor does not activate within 18 seconds after the lift motor turns on (in UP direction) when the main switch is turned on or close the LCT cover. • The lower limit sensor does |
SC193 | Description: IDU error - Timing - When the main switch is turned on - Condition - The IDU starts diagnosing at power-on and any hardware error is detected during diagnostics. |
SC501 | Description: 1st paper tray error - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate goes down. • The upper limit sensor stays HIGH 10 |
The most common error codes.
Error | |
---|---|
SC401 | Description: Image transfer belt motor lock - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal is sent. • The feedback signal becomes out of range for 2 seconds while the trigger signal is |
SC604 | Description: IDU communication error - Timing & Condition - No response is received from the IDU within 200 ms after the scanner IP board sends a command signal and this error is detected 3 times in total. |
SC742 | Description: LCT: Tray lift error - Timing & Condition - • The upper limit sensor does not activate within 18 seconds after the lift motor turns on (in UP direction) when the main switch is turned on or close the LCT cover. • The lower limit sensor does |
SC193 | Description: IDU error - Timing - When the main switch is turned on - Condition - The IDU starts diagnosing at power-on and any hardware error is detected during diagnostics. |
SC501 | Description: 1st paper tray error - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate goes down. • The upper limit sensor stays HIGH 10 |
SC401 | Description: Image transfer belt motor lock - Timing & Condition - • The feedback signal from the motor is still out of range 2 seconds after the trigger signal is sent. • The feedback signal becomes out of range for 2 seconds while the trigger signal is |
SC604 | Description: IDU communication error - Timing & Condition - No response is received from the IDU within 200 ms after the scanner IP board sends a command signal and this error is detected 3 times in total. |
SC742 | Description: LCT: Tray lift error - Timing & Condition - • The upper limit sensor does not activate within 18 seconds after the lift motor turns on (in UP direction) when the main switch is turned on or close the LCT cover. • The lower limit sensor does |
SC193 | Description: IDU error - Timing - When the main switch is turned on - Condition - The IDU starts diagnosing at power-on and any hardware error is detected during diagnostics. |
SC501 | Description: 1st paper tray error - Timing & Condition - • The upper limit sensor stays HIGH when the pick-up solenoid turns off. • The upper limit sensor stays LOW 1.5 seconds after the tray bottom plate goes down. • The upper limit sensor stays HIGH 10 |