Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio 470W Top Searches

These results are ranked by popularity.

Error
SC551Description: Left fusing pressure motor home position error 2 The left pressure motor was still at the home position 1.5 s after the start signal turned on.
SC391Description: Development bias error A development bias feedback voltage of less than 0.25V was detected for more than 200 ms while the PWM duty value was more than 1% (development bias leak).
SC980Description: HDD access error Incorrect parameter sent to the HDC (hard disk controller chip mounted on the IPU) from the BICU.
SC513Description: Cutter 2 home position error 3 SC513-1 The right home position switch stays off 1 s after the cutter starts moving from left to right. SC513-2 The left home position switch stays off 1 s after the cutter starts moving from right to left.
SC192Description: AMDP download error The AMDP ROM enable signal could not be detected within 8 ms after program download to the AMDP started. Program download failed three times consecutively.

Ricoh Aficio 470W Common Errors

The most common error codes.

Error
SC551Description: Left fusing pressure motor home position error 2 The left pressure motor was still at the home position 1.5 s after the start signal turned on.
SC391Description: Development bias error A development bias feedback voltage of less than 0.25V was detected for more than 200 ms while the PWM duty value was more than 1% (development bias leak).
SC980Description: HDD access error Incorrect parameter sent to the HDC (hard disk controller chip mounted on the IPU) from the BICU.
SC513Description: Cutter 2 home position error 3 SC513-1 The right home position switch stays off 1 s after the cutter starts moving from left to right. SC513-2 The left home position switch stays off 1 s after the cutter starts moving from right to left.
SC192Description: AMDP download error The AMDP ROM enable signal could not be detected within 8 ms after program download to the AMDP started. Program download failed three times consecutively.
SC551Description: Left fusing pressure motor home position error 2 The left pressure motor was still at the home position 1.5 s after the start signal turned on.
SC391Description: Development bias error A development bias feedback voltage of less than 0.25V was detected for more than 200 ms while the PWM duty value was more than 1% (development bias leak).
SC980Description: HDD access error Incorrect parameter sent to the HDC (hard disk controller chip mounted on the IPU) from the BICU.
SC513Description: Cutter 2 home position error 3 SC513-1 The right home position switch stays off 1 s after the cutter starts moving from left to right. SC513-2 The left home position switch stays off 1 s after the cutter starts moving from right to left.
SC192Description: AMDP download error The AMDP ROM enable signal could not be detected within 8 ms after program download to the AMDP started. Program download failed three times consecutively.