Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio 3030 Top Searches

These results are ranked by popularity.

Error
840Description: EEPROM error 1 During input/output with the EEPROM on the controller board, one of the following errors occurred: • A read error occurred and continued after 3 retries. • A write error occurred.
612Description: Communication command error between SBCU and ADF
351Description: ID sensor calibration - Error 2 The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: • Vsg = 5V • PWM = 0 (LED current drop)
990Description: Software performance error The software attempted to perform an unexpected operation.
725Description: Finisher stack feed-out motor error - 1000-sheet Finisher B408 The stack feed-out belt H.P sensor does not activate within a certain time after the stack feed-out motor turned on.

Ricoh Aficio 3030 Common Errors

The most common error codes.

Error
840Description: EEPROM error 1 During input/output with the EEPROM on the controller board, one of the following errors occurred: • A read error occurred and continued after 3 retries. • A write error occurred.
612Description: Communication command error between SBCU and ADF
351Description: ID sensor calibration - Error 2 The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: • Vsg = 5V • PWM = 0 (LED current drop)
990Description: Software performance error The software attempted to perform an unexpected operation.
725Description: Finisher stack feed-out motor error - 1000-sheet Finisher B408 The stack feed-out belt H.P sensor does not activate within a certain time after the stack feed-out motor turned on.
840Description: EEPROM error 1 During input/output with the EEPROM on the controller board, one of the following errors occurred: • A read error occurred and continued after 3 retries. • A write error occurred.
612Description: Communication command error between SBCU and ADF
351Description: ID sensor calibration - Error 2 The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: • Vsg = 5V • PWM = 0 (LED current drop)
990Description: Software performance error The software attempted to perform an unexpected operation.
725Description: Finisher stack feed-out motor error - 1000-sheet Finisher B408 The stack feed-out belt H.P sensor does not activate within a certain time after the stack feed-out motor turned on.