Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio 2232C Top Searches

These results are ranked by popularity.

Error
552Description: Pressure roller warm-up error After the main switch is turned on or the door is closed, the pressure roller temperature does not reach the ready temperature within 180 seconds during fusing unit warm-up.
374Description: Vt error [K] During the image development, Vt value is less than 0.5V.
854Description: Wireless LAN card not detected
731Description: Two-tray finisher exit guide plate motor error The exit guide plate open sensor is not activated within a specified time after the exit guide plate motor turns on.
390Description: Development Bias output error The high voltage supply board (C/B) monitors the circuit and detects abnormal conditions such as a voltage leak or no output condition. If this happens, the high voltage supply board sends an error signal (High

Ricoh Aficio 2232C Common Errors

The most common error codes.

Error
552Description: Pressure roller warm-up error After the main switch is turned on or the door is closed, the pressure roller temperature does not reach the ready temperature within 180 seconds during fusing unit warm-up.
374Description: Vt error [K] During the image development, Vt value is less than 0.5V.
854Description: Wireless LAN card not detected
731Description: Two-tray finisher exit guide plate motor error The exit guide plate open sensor is not activated within a specified time after the exit guide plate motor turns on.
390Description: Development Bias output error The high voltage supply board (C/B) monitors the circuit and detects abnormal conditions such as a voltage leak or no output condition. If this happens, the high voltage supply board sends an error signal (High
552Description: Pressure roller warm-up error After the main switch is turned on or the door is closed, the pressure roller temperature does not reach the ready temperature within 180 seconds during fusing unit warm-up.
374Description: Vt error [K] During the image development, Vt value is less than 0.5V.
854Description: Wireless LAN card not detected
731Description: Two-tray finisher exit guide plate motor error The exit guide plate open sensor is not activated within a specified time after the exit guide plate motor turns on.
390Description: Development Bias output error The high voltage supply board (C/B) monitors the circuit and detects abnormal conditions such as a voltage leak or no output condition. If this happens, the high voltage supply board sends an error signal (High