These results are ranked by popularity.
| Error | |
|---|---|
| 744 | Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. |
| 726 | Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray. |
| 545 | Description: Fusing lamp overheat error 2 After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating. |
| 822 | Description: Self-diagnostic error 3: HDD |
| 964 | Description: Printer ready error The print ready signal is not generated for more than 17 seconds after the IPU received the print start signal. |
The most common error codes.
| Error | |
|---|---|
| 744 | Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. |
| 726 | Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray. |
| 545 | Description: Fusing lamp overheat error 2 After hot roller reaches warmup temperature, the fusing lamps remained on at full capacity for 11 samplings (1.8 sec. duration) while the hot roller was not rotating. |
| 822 | Description: Self-diagnostic error 3: HDD |
| 964 | Description: Printer ready error The print ready signal is not generated for more than 17 seconds after the IPU received the print start signal. |
| 726 | Description: Finisher upper tray lift motor error B140 The paper height sensor does not activate within the prescribed time after the upper tray lift motor turns on, or the sensor remains on after the motor reverses to lower the tray. |
| 336 | Description: Polygon mirror motor error 2 The ready signal does not go high within 20 s after the polygonal mirror motor turns off. |
| 744 | Description: Booklet stapler motor error 2 B246 The rear stapler unit saddle-stitch motor does not start operation within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code. |
| 822 | Description: Self-diagnostic error 3: HDD |
| 964 | Description: Printer ready error The print ready signal is not generated for more than 17 seconds after the IPU received the print start signal. |
