Ricoh Aficio 1045G Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio 1045G Top Searches

These results are ranked by popularity.

Error
502Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect
951Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal.
724Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on.
323Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD.
822Description: Self-Diagnostic Error: HDD The hard disk drive returned an error during the self-diagnostic test.

Ricoh Aficio 1045G Common Errors

The most common error codes.

Error
502Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect
951Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal.
724Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on.
323Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD.
822Description: Self-Diagnostic Error: HDD The hard disk drive returned an error during the self-diagnostic test.
502Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect
951Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal.
724Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on.
323Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD.
822Description: Self-Diagnostic Error: HDD The hard disk drive returned an error during the self-diagnostic test.