Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh Aficio 1035P Top Searches

These results are ranked by popularity.

Error
724Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on.
502Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect
951Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal.
601Description: Communication error between BICU and scanner unit Within 800 ms after power on, after 3 attempts the BICU does not communicate with the SIB via the serial line.
323Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD.

Ricoh Aficio 1035P Common Errors

The most common error codes.

Error
724Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on.
502Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect
951Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal.
601Description: Communication error between BICU and scanner unit Within 800 ms after power on, after 3 attempts the BICU does not communicate with the SIB via the serial line.
323Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD.
724Description: Finisher staple hammer motor error Stapling does not finish within 600 ms after the staple hammer motor turned on.
502Description: 2nd tray lift malfunction The paper height sensor is not activated after the tray lift motor has been on for 10 seconds. If the main power switch is turned on when the paper is already at the feed height, the paper height position is detect
951Description: F-gate error at write request After the IPU receives an F-gate signal, it receives another F-gate signal.
601Description: Communication error between BICU and scanner unit Within 800 ms after power on, after 3 attempts the BICU does not communicate with the SIB via the serial line.
323Description: LD drive current too high • The LD drive board applies more than 100 mA to the LD.