Ricoh MP402SPF Error Code SC332-00
|
|
|---|
|
|
| Description: Toner supply feed lock Under the condition that the Toner Cartridge has not reached the end, an error that no toner is supplied has been detected over n times in succession. n: The value was specified at SP2-931-005. |
|
|
| Causes: • Overloaded toner feeding system (toner clogging) • Detection screw of the PCDU not rotating • Failure in the sensing element (sensor): Light leak • Failure in the toner supply pawl • Failure in the toner supply clutch |
|
|
| Remedy: • Replace the Toner Cartridge. • Replace the PCDU |
|
|
Ricoh MP402SPF Top Searches
These results are ranked by popularity.
| Error | |
|---|---|
| SC998-00 | Description: Application start error • After power ON, no application program was registered to the system within the specified period of time. (No application started or ended normally.). • Even though the application started up, it cannot be rendered d |
| SC859-10 | Description: Data encryption conversion HDD conversion error (Data read/write command error) HDD was not converted correctly during an attempt to update the encryption key. Only an error screen is displayed and no SC is issued during conversion. This SC |
| SC667-40 | Description: Macaron Mode Setting Error The machine detects the Macaron1 mode error when starting up, or recovery from energy saver mode. |
| SC543-00 | Description: Fusing (Center) thermopile high-temperature detected (software) The temperature is detected to stay at 250 degrees C or higher for one second. |
| SC868-01 | Description: SD card access error The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd1) |
Ricoh MP402SPF Common Errors
The most common error codes.
| Error | |
|---|---|
| SC998-00 | Description: Application start error • After power ON, no application program was registered to the system within the specified period of time. (No application started or ended normally.). • Even though the application started up, it cannot be rendered d |
| SC859-10 | Description: Data encryption conversion HDD conversion error (Data read/write command error) HDD was not converted correctly during an attempt to update the encryption key. Only an error screen is displayed and no SC is issued during conversion. This SC |
| SC667-40 | Description: Macaron Mode Setting Error The machine detects the Macaron1 mode error when starting up, or recovery from energy saver mode. |
| SC543-00 | Description: Fusing (Center) thermopile high-temperature detected (software) The temperature is detected to stay at 250 degrees C or higher for one second. |
| SC868-01 | Description: SD card access error The SD controller returned an error during operation. (An error occurred at the mount point of /mnt/sd1) |
| SC543-00 | Description: Fusing (Center) thermopile high-temperature detected (software) The temperature is detected to stay at 250 degrees C or higher for one second. |
| SC998-00 | Description: Application start error • After power ON, no application program was registered to the system within the specified period of time. (No application started or ended normally.). • Even though the application started up, it cannot be rendered d |
| SC859-10 | Description: Data encryption conversion HDD conversion error (Data read/write command error) HDD was not converted correctly during an attempt to update the encryption key. Only an error screen is displayed and no SC is issued during conversion. This SC |
| SC667-40 | Description: Macaron Mode Setting Error The machine detects the Macaron1 mode error when starting up, or recovery from energy saver mode. |
| SC151-00 | Description: Black level correction error: rear side The automatic adjustment has failed to correct the black level (rear side) to the permissible range. |