These results are ranked by popularity.
Error | |
---|---|
221.91 | Description: Paper remains detected at the sensor (redrive buckle) after the printer is turned on. |
149.80...149.85 | Description: 149.80 The motor (redrive) did not turn on. 149.81 The motor (redrive) did not turn off. 149.82 The motor (redrive) speed did not ramp up to the required level. 149.83 The motor (redrive) stalled. 149.84 The motor (redrive) ran too slow. 149 |
420.11 | Description: The media, with the leading edge on the compiler section, remains detected by sensor (staple finisher transport) during warm.up sequence. |
243.x6 | Description: 243.46 Paper fed from tray 4 was picked but it never arrived at the sensor (tray 3 passthrough). 243.96 Paper was picked but it never arrived at the sensor (tray 3 pass-through). Paper source is undetermined. |
61, 62 | Description: 61 The hard disk is defective. 62 The hard disk is full. |
The most common error codes.
Error | |
---|---|
221.91 | Description: Paper remains detected at the sensor (redrive buckle) after the printer is turned on. |
149.80...149.85 | Description: 149.80 The motor (redrive) did not turn on. 149.81 The motor (redrive) did not turn off. 149.82 The motor (redrive) speed did not ramp up to the required level. 149.83 The motor (redrive) stalled. 149.84 The motor (redrive) ran too slow. 149 |
420.11 | Description: The media, with the leading edge on the compiler section, remains detected by sensor (staple finisher transport) during warm.up sequence. |
243.x6 | Description: 243.46 Paper fed from tray 4 was picked but it never arrived at the sensor (tray 3 passthrough). 243.96 Paper was picked but it never arrived at the sensor (tray 3 pass-through). Paper source is undetermined. |
61, 62 | Description: 61 The hard disk is defective. 62 The hard disk is full. |
221.91 | Description: Paper remains detected at the sensor (redrive buckle) after the printer is turned on. |
149.80...149.85 | Description: 149.80 The motor (redrive) did not turn on. 149.81 The motor (redrive) did not turn off. 149.82 The motor (redrive) speed did not ramp up to the required level. 149.83 The motor (redrive) stalled. 149.84 The motor (redrive) ran too slow. 149 |
420.11 | Description: The media, with the leading edge on the compiler section, remains detected by sensor (staple finisher transport) during warm.up sequence. |
243.x6 | Description: 243.46 Paper fed from tray 4 was picked but it never arrived at the sensor (tray 3 passthrough). 243.96 Paper was picked but it never arrived at the sensor (tray 3 pass-through). Paper source is undetermined. |
61, 62 | Description: 61 The hard disk is defective. 62 The hard disk is full. |