These results are ranked by popularity.
Error | |
---|---|
956.00 | Description: Service system board RIP card assembly processor failure The RIP card processor has failed. |
84 | Description: Replace PC unit PC cartridge end of life The PC cartridge needs to be replaced. |
985.01 | Description: Service finisher error Sensor (punch carriage shift HP) off failure |
845.02 | Description: Service scanner failure CCD initialization (lamp off) failure The CCD does not make a correct output when light is absent. |
290.01 | Description: Scanner jam Remove all originals from the scanner. Sensor (sheet through) on jam After the first feed operation started, the feed drive motor turned on (CW)) in Duplex mode, the sensor (sheet through) did not turn on within the specified tim |
The most common error codes.
Error | |
---|---|
956.00 | Description: Service system board RIP card assembly processor failure The RIP card processor has failed. |
84 | Description: Replace PC unit PC cartridge end of life The PC cartridge needs to be replaced. |
985.01 | Description: Service finisher error Sensor (punch carriage shift HP) off failure |
845.02 | Description: Service scanner failure CCD initialization (lamp off) failure The CCD does not make a correct output when light is absent. |
290.01 | Description: Scanner jam Remove all originals from the scanner. Sensor (sheet through) on jam After the first feed operation started, the feed drive motor turned on (CW)) in Duplex mode, the sensor (sheet through) did not turn on within the specified tim |
956.00 | Description: Service system board RIP card assembly processor failure The RIP card processor has failed. |
84 | Description: Replace PC unit PC cartridge end of life The PC cartridge needs to be replaced. |
985.01 | Description: Service finisher error Sensor (punch carriage shift HP) off failure |
845.02 | Description: Service scanner failure CCD initialization (lamp off) failure The CCD does not make a correct output when light is absent. |
290.01 | Description: Scanner jam Remove all originals from the scanner. Sensor (sheet through) on jam After the first feed operation started, the feed drive motor turned on (CW)) in Duplex mode, the sensor (sheet through) did not turn on within the specified tim |