Kyocera FSC5350DN Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera FSC5350DN Top Searches

These results are ranked by popularity.

Error
5303Description: Broken eraser lamp M wire When the eraser lamp M is driven, the eraser lamp M over-current detection signal is detected continuously for 10 times (1 s) at 100 ms intervals.
7402Description: Developing unit C non-installing error No density detection signal is output from toner sensor C in developing unit C.
1010Description: Lift motor error When the lift motor is driven, the lift motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals. After the lift motor is driven, the ON status of lift limit sensor cannot be detect
F030Description: Main PWB general failure
4001Description: Polygon motor YK error The polygon motor YK ready input is not given for 10 seconds during the polygon motor YK is ON.

Kyocera FSC5350DN Common Errors

The most common error codes.

Error
5303Description: Broken eraser lamp M wire When the eraser lamp M is driven, the eraser lamp M over-current detection signal is detected continuously for 10 times (1 s) at 100 ms intervals.
7402Description: Developing unit C non-installing error No density detection signal is output from toner sensor C in developing unit C.
1010Description: Lift motor error When the lift motor is driven, the lift motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals. After the lift motor is driven, the ON status of lift limit sensor cannot be detect
F030Description: Main PWB general failure
4001Description: Polygon motor YK error The polygon motor YK ready input is not given for 10 seconds during the polygon motor YK is ON.
5303Description: Broken eraser lamp M wire When the eraser lamp M is driven, the eraser lamp M over-current detection signal is detected continuously for 10 times (1 s) at 100 ms intervals.
7402Description: Developing unit C non-installing error No density detection signal is output from toner sensor C in developing unit C.
1010Description: Lift motor error When the lift motor is driven, the lift motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals. After the lift motor is driven, the ON status of lift limit sensor cannot be detect
F030Description: Main PWB general failure
4001Description: Polygon motor YK error The polygon motor YK ready input is not given for 10 seconds during the polygon motor YK is ON.