Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera FSC5150DN Top Searches

These results are ranked by popularity.

Error
7003Description: Toner motor M error When the toner motor M is driven, the motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals.
1600Description: PF heater 1 low temperature error (paper feeder 1) An external temperature higher than + 5C/+ 9F is not detected when one minute elapses after PF heater 1 is turned on.
2730Description: Developing release motor error When the developing release motor is driven, the motor over-current detection signal is detected continuously for 8 times (800 ms) at 100 ms intervals.
F050Description: Print engine ROM checksum error
2500Description: Paper feed motor error The drum motor ready input is not given for 5 s during the paper feed motor is ON.

Kyocera FSC5150DN Common Errors

The most common error codes.

Error
7003Description: Toner motor M error When the toner motor M is driven, the motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals.
1600Description: PF heater 1 low temperature error (paper feeder 1) An external temperature higher than + 5C/+ 9F is not detected when one minute elapses after PF heater 1 is turned on.
2730Description: Developing release motor error When the developing release motor is driven, the motor over-current detection signal is detected continuously for 8 times (800 ms) at 100 ms intervals.
F050Description: Print engine ROM checksum error
2500Description: Paper feed motor error The drum motor ready input is not given for 5 s during the paper feed motor is ON.
7003Description: Toner motor M error When the toner motor M is driven, the motor over-current detection signal is detected continuously for 50 times (5 s) at 100 ms intervals.
1600Description: PF heater 1 low temperature error (paper feeder 1) An external temperature higher than + 5C/+ 9F is not detected when one minute elapses after PF heater 1 is turned on.
2730Description: Developing release motor error When the developing release motor is driven, the motor over-current detection signal is detected continuously for 8 times (800 ms) at 100 ms intervals.
F050Description: Print engine ROM checksum error
2500Description: Paper feed motor error The drum motor ready input is not given for 5 s during the paper feed motor is ON.