Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera FSC5100DN Top Searches

These results are ranked by popularity.

Error
4202Description: Laser output error (Cyan) The pin photo signal (PDN) is not output from PD PWB C for one second while laser is emitted.
6030Description: Broken fuser thermistor wire Input from fuser thermistor is 0 (A/D value).
7003Description: Toner motor M error Over-current at toner motor M is detected for 80 ms in total while toner motor M is ON.
0130Description: Backup memory (EEPROM) read/write error [Main PWB] Reading from / writing to EEPROM (U4) cannot be performed.
1600, 1620, 1640Description: PF warm air heater (upper blower) low temperature error* (Option paper feeder) An external temperature higher than +5°C/+41°F is not detected when one minute elapses after PF warm air heater 2 is turned on. *: Multi purpose feeder only 1600:

Kyocera FSC5100DN Common Errors

The most common error codes.

Error
4202Description: Laser output error (Cyan) The pin photo signal (PDN) is not output from PD PWB C for one second while laser is emitted.
6030Description: Broken fuser thermistor wire Input from fuser thermistor is 0 (A/D value).
7003Description: Toner motor M error Over-current at toner motor M is detected for 80 ms in total while toner motor M is ON.
0130Description: Backup memory (EEPROM) read/write error [Main PWB] Reading from / writing to EEPROM (U4) cannot be performed.
1600, 1620, 1640Description: PF warm air heater (upper blower) low temperature error* (Option paper feeder) An external temperature higher than +5°C/+41°F is not detected when one minute elapses after PF warm air heater 2 is turned on. *: Multi purpose feeder only 1600:
4202Description: Laser output error (Cyan) The pin photo signal (PDN) is not output from PD PWB C for one second while laser is emitted.
6030Description: Broken fuser thermistor wire Input from fuser thermistor is 0 (A/D value).
7003Description: Toner motor M error Over-current at toner motor M is detected for 80 ms in total while toner motor M is ON.
0130Description: Backup memory (EEPROM) read/write error [Main PWB] Reading from / writing to EEPROM (U4) cannot be performed.
1600, 1620, 1640Description: PF warm air heater (upper blower) low temperature error* (Option paper feeder) An external temperature higher than +5°C/+41°F is not detected when one minute elapses after PF warm air heater 2 is turned on. *: Multi purpose feeder only 1600: