Kyocera FS3540MFP Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera FS3540MFP Top Searches

These results are ranked by popularity.

Error
7000Description: Toner motor lock error During driving the toner motor, a motor overcurrent signal is detected for 5 s.
0830Description: FAX control PWB flash program area checksum error A checksum error occurred with the program of the FAX control PWB.
4000Description: Polygon motor synchronization error The polygon motor ready input is not given for 10 s during the polygon motor is ON.
7410Description: Drum unit non- installing error The drum unit is not installed or not installed properly. The drum PWB EEPROM does not communicate normally.
0030Description: FAX control PWB system error Processing with the fax software was disabled due to a hardware problem.

Kyocera FS3540MFP Common Errors

The most common error codes.

Error
7000Description: Toner motor lock error During driving the toner motor, a motor overcurrent signal is detected for 5 s.
0830Description: FAX control PWB flash program area checksum error A checksum error occurred with the program of the FAX control PWB.
4000Description: Polygon motor synchronization error The polygon motor ready input is not given for 10 s during the polygon motor is ON.
7410Description: Drum unit non- installing error The drum unit is not installed or not installed properly. The drum PWB EEPROM does not communicate normally.
0030Description: FAX control PWB system error Processing with the fax software was disabled due to a hardware problem.
7000Description: Toner motor lock error During driving the toner motor, a motor overcurrent signal is detected for 5 s.
0830Description: FAX control PWB flash program area checksum error A checksum error occurred with the program of the FAX control PWB.
4000Description: Polygon motor synchronization error The polygon motor ready input is not given for 10 s during the polygon motor is ON.
7410Description: Drum unit non- installing error The drum unit is not installed or not installed properly. The drum PWB EEPROM does not communicate normally.
0030Description: FAX control PWB system error Processing with the fax software was disabled due to a hardware problem.