Error |
---|
These results are ranked by popularity.
Error | |
---|---|
E46-26 | Description: Image control abnormality Correction data saved on a resolution basis is not found. |
F77-46 | Description: ZK-2/3 Akit abnormality EM signal abnormality is detected within the specified time after FM701 (stacker fan) is turned ON. |
F52-01 | Description: Fan abnormality FM13 (power supply cooling) EM signal was abnormal 2 seconds after turning ON FM13. 2 seconds after turning FM13 OFF and ON again, the signal is still abnormal. |
F29-07 | Description: Process abnormality Dirt correction failure of the ? sensor during dot diameter adjustment. If this error is detected 10 successive times, the corresponding error code is displayed. |
F13-01 | Description: Drive Error detection signal is detected continuously for one second when two seconds have passed since M1 (paper feed) has turned ON. |
The most common error codes.
Error | |
---|---|
E46-26 | Description: Image control abnormality Correction data saved on a resolution basis is not found. |
F77-46 | Description: ZK-2/3 Akit abnormality EM signal abnormality is detected within the specified time after FM701 (stacker fan) is turned ON. |
F52-01 | Description: Fan abnormality FM13 (power supply cooling) EM signal was abnormal 2 seconds after turning ON FM13. 2 seconds after turning FM13 OFF and ON again, the signal is still abnormal. |
F29-07 | Description: Process abnormality Dirt correction failure of the ? sensor during dot diameter adjustment. If this error is detected 10 successive times, the corresponding error code is displayed. |
F13-01 | Description: Drive Error detection signal is detected continuously for one second when two seconds have passed since M1 (paper feed) has turned ON. |
E46-26 | Description: Image control abnormality Correction data saved on a resolution basis is not found. |
F77-46 | Description: ZK-2/3 Akit abnormality EM signal abnormality is detected within the specified time after FM701 (stacker fan) is turned ON. |
F52-01 | Description: Fan abnormality FM13 (power supply cooling) EM signal was abnormal 2 seconds after turning ON FM13. 2 seconds after turning FM13 OFF and ON again, the signal is still abnormal. |
F29-07 | Description: Process abnormality Dirt correction failure of the ? sensor during dot diameter adjustment. If this error is detected 10 successive times, the corresponding error code is displayed. |
F13-01 | Description: Drive Error detection signal is detected continuously for one second when two seconds have passed since M1 (paper feed) has turned ON. |