Konica-Minolta Bizhub 42 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub 42 Top Searches

These results are ranked by popularity.

Error
0B05Description: Malfunctioning of belt up/down movement (FS-529) • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor (PS13) is not turne
C074Description: Engine ROM error ROM on the printer control board has error.
0001Description: Transport motor's turning at abnormal timing The motor lock signal remains LOW for a predetermined continuous period of time while the motor remains stationary.
1340Description: FPGA configuration error When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.
0F3DDescription: TCR sensor adjustment failure TCR sensor automatic adjustment does not function properly, failing to adjust to an appropriate value.

Konica-Minolta Bizhub 42 Common Errors

The most common error codes.

Error
0B05Description: Malfunctioning of belt up/down movement (FS-529) • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor (PS13) is not turne
C074Description: Engine ROM error ROM on the printer control board has error.
0001Description: Transport motor's turning at abnormal timing The motor lock signal remains LOW for a predetermined continuous period of time while the motor remains stationary.
1340Description: FPGA configuration error When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.
0F3DDescription: TCR sensor adjustment failure TCR sensor automatic adjustment does not function properly, failing to adjust to an appropriate value.
0B05Description: Malfunctioning of belt up/down movement (FS-529) • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor (PS13) is not turne
C074Description: Engine ROM error ROM on the printer control board has error.
0001Description: Transport motor's turning at abnormal timing The motor lock signal remains LOW for a predetermined continuous period of time while the motor remains stationary.
1340Description: FPGA configuration error When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.
0F3DDescription: TCR sensor adjustment failure TCR sensor automatic adjustment does not function properly, failing to adjust to an appropriate value.