Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Konica-Minolta Bizhub 283 Top Searches

These results are ranked by popularity.

Error
C1181Description: Malfunctioning of belt up/ down movement • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor
CC153Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of the PRCB during starting.
C3421Description: Fusing heaters trouble (center) • Detected temperature of the heating roller thermistor (TH2; center) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The warm-up is not completed even aft
C0001Description: LCT communication error • Due to malfunctioning of the software or other causes, the watchdog timer triggers a reset when time is up.
C5602Description: FPGA configuration error • When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.

Konica-Minolta Bizhub 283 Common Errors

The most common error codes.

Error
C1181Description: Malfunctioning of belt up/ down movement • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor
CC153Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of the PRCB during starting.
C3421Description: Fusing heaters trouble (center) • Detected temperature of the heating roller thermistor (TH2; center) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The warm-up is not completed even aft
C0001Description: LCT communication error • Due to malfunctioning of the software or other causes, the watchdog timer triggers a reset when time is up.
C5602Description: FPGA configuration error • When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.
C1181Description: Malfunctioning of belt up/ down movement • The belt position sensor (PS13) is not turned OFF after the set period of time has elapsed after the belt retract solenoid (SD5) is turned ON. • The belt position sensor
CC153Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of the PRCB during starting.
C3421Description: Fusing heaters trouble (center) • Detected temperature of the heating roller thermistor (TH2; center) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The warm-up is not completed even aft
C0001Description: LCT communication error • Due to malfunctioning of the software or other causes, the watchdog timer triggers a reset when time is up.
C5602Description: FPGA configuration error • When a configuration check is performed on the extended IC chip (FPGA) located on the printer control board (PRCB), error is detected.