HP DesignJet L25500 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


HP DesignJet L25500 Top Searches

These results are ranked by popularity.

Error
41:03Description: Limited electrical voltage at the Media Axis motor. Electrical current limit in paper motor.
51.01:10Description: Problem with the Service Station door sensor. Error detected with the sensor on the Service Station Door.
14.07:00Description: Connection problem with Heaters Control assembly. I2C Protocol not working. The firmware has detected that there is no communication to/from the Heaters Control Assembly and the Printmech PCA.
74:04Description: Request to upgrade the firmware. This error is displayed when the current firmware does not support the installed PrintMech PCA.
16.01:00Description: Curing Module warm up time out. Curing System unable to warm up in the pre-defined amount of time: 9 minutes (45C for standby & normally 95C for printing).

HP DesignJet L25500 Common Errors

The most common error codes.

Error
41:03Description: Limited electrical voltage at the Media Axis motor. Electrical current limit in paper motor.
51.01:10Description: Problem with the Service Station door sensor. Error detected with the sensor on the Service Station Door.
14.07:00Description: Connection problem with Heaters Control assembly. I2C Protocol not working. The firmware has detected that there is no communication to/from the Heaters Control Assembly and the Printmech PCA.
74:04Description: Request to upgrade the firmware. This error is displayed when the current firmware does not support the installed PrintMech PCA.
16.01:00Description: Curing Module warm up time out. Curing System unable to warm up in the pre-defined amount of time: 9 minutes (45C for standby & normally 95C for printing).
41:03Description: Limited electrical voltage at the Media Axis motor. Electrical current limit in paper motor.
51.01:10Description: Problem with the Service Station door sensor. Error detected with the sensor on the Service Station Door.
14.07:00Description: Connection problem with Heaters Control assembly. I2C Protocol not working. The firmware has detected that there is no communication to/from the Heaters Control Assembly and the Printmech PCA.
74:04Description: Request to upgrade the firmware. This error is displayed when the current firmware does not support the installed PrintMech PCA.
16.01:00Description: Curing Module warm up time out. Curing System unable to warm up in the pre-defined amount of time: 9 minutes (45C for standby & normally 95C for printing).