HP DesignJet 9000s Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


HP DesignJet 9000s Top Searches

These results are ranked by popularity.

Error
126xDescription: Trailing Cable Connection Error The Trailing Cable connected to the one of the following connectors is faulty. x = 0: Connector 9. x = 1: Connector 10. x = 2: Connector 11. x = 3: Connector 12.
H05Description: Center Heater Temperature Error Temperature read by the Center Heater is abnormal (lower than -10C or higher than 70C).
0400Description: USB Register The read/write of the USB controller on the Main PCA was diagnosed and an error was detected.
11AxDescription: NVRAM Error The data in the NVRAM is incorrect.
1700Description: Servo Motor Error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change.

HP DesignJet 9000s Common Errors

The most common error codes.

Error
126xDescription: Trailing Cable Connection Error The Trailing Cable connected to the one of the following connectors is faulty. x = 0: Connector 9. x = 1: Connector 10. x = 2: Connector 11. x = 3: Connector 12.
H05Description: Center Heater Temperature Error Temperature read by the Center Heater is abnormal (lower than -10C or higher than 70C).
0400Description: USB Register The read/write of the USB controller on the Main PCA was diagnosed and an error was detected.
11AxDescription: NVRAM Error The data in the NVRAM is incorrect.
1700Description: Servo Motor Error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change.
126xDescription: Trailing Cable Connection Error The Trailing Cable connected to the one of the following connectors is faulty. x = 0: Connector 9. x = 1: Connector 10. x = 2: Connector 11. x = 3: Connector 12.
H05Description: Center Heater Temperature Error Temperature read by the Center Heater is abnormal (lower than -10C or higher than 70C).
0400Description: USB Register The read/write of the USB controller on the Main PCA was diagnosed and an error was detected.
11AxDescription: NVRAM Error The data in the NVRAM is incorrect.
1700Description: Servo Motor Error The Paper-Axis or the Scan-Axis Motor moves the Carriage, but the input from the Linear Encoder Sensor does not change.