These results are ranked by popularity.
Error | |
---|---|
E540-8004 | Description: Tray up/down error When the input of the clock signal could not be detected within 0.2 sec. during the operation of the 1st tray shift motor |
E351-0000 | Description: Main controller PCB error When a communication error has occurred in the main controller PCB at startup |
E020-xx60 | Description: Concerning the first two digits of the details code in xx12 to xxD0 xx=01: Y xx=02: M xx=03: C xx=04: Bk Incorrect developer density target value which was set when the new drum unit was installed (value is extremely low) |
E719-0001 | Description: Error in communication with coin vendor/card reader When the coin vendor which was connected before the power was turned OFF could not be recognized when the power was turned back ON |
E004-0401 | Description: Fixing unit protection circuit trouble 13 V trouble error |
The most common error codes.
Error | |
---|---|
E540-8004 | Description: Tray up/down error When the input of the clock signal could not be detected within 0.2 sec. during the operation of the 1st tray shift motor |
E351-0000 | Description: Main controller PCB error When a communication error has occurred in the main controller PCB at startup |
E020-xx60 | Description: Concerning the first two digits of the details code in xx12 to xxD0 xx=01: Y xx=02: M xx=03: C xx=04: Bk Incorrect developer density target value which was set when the new drum unit was installed (value is extremely low) |
E719-0001 | Description: Error in communication with coin vendor/card reader When the coin vendor which was connected before the power was turned OFF could not be recognized when the power was turned back ON |
E004-0401 | Description: Fixing unit protection circuit trouble 13 V trouble error |
E540-8004 | Description: Tray up/down error When the input of the clock signal could not be detected within 0.2 sec. during the operation of the 1st tray shift motor |
E351-0000 | Description: Main controller PCB error When a communication error has occurred in the main controller PCB at startup |
E020-xx60 | Description: Concerning the first two digits of the details code in xx12 to xxD0 xx=01: Y xx=02: M xx=03: C xx=04: Bk Incorrect developer density target value which was set when the new drum unit was installed (value is extremely low) |
E719-0001 | Description: Error in communication with coin vendor/card reader When the coin vendor which was connected before the power was turned OFF could not be recognized when the power was turned back ON |
E004-0401 | Description: Fixing unit protection circuit trouble 13 V trouble error |