These results are ranked by popularity.
Error | |
---|---|
E002-0002 | Description: The rise in temperature of the fixing unit is inadequate. The output of the non-contact thermistor does not reach 60°C within 240 sec after it has reached 40°C. |
E606-0002 | Description: The hard disk is faulty. A reading error is detected when the HD is booted from BOOTROM. |
E504-0002 | Description: There is a fault in stack size detection. Finisher-N1/Saddle Finisher-N2 The height sensor (PS1) is faulty. The communication between the height sensor and the finisher controller PCB is prevented for 0.1 sec or more. |
E712 | Description: There is a fault in the communication between the ADF and the reader unit. DADF-K1 There is a fault in data communication. The ADF controller or the reader controller PCB is faulty. The connector between the reader unit an the ADF has poor |
E537 | Description: There is a fault in front alignment. Finisher-M1 The front alignment motor (M3) or the front aligning plate home position sensor (S6) is faulty. An excess load is imposed on the front aligning plate. The aligning plate fails to reach the al |
The most common error codes.
Error | |
---|---|
E002-0002 | Description: The rise in temperature of the fixing unit is inadequate. The output of the non-contact thermistor does not reach 60°C within 240 sec after it has reached 40°C. |
E606-0002 | Description: The hard disk is faulty. A reading error is detected when the HD is booted from BOOTROM. |
E504-0002 | Description: There is a fault in stack size detection. Finisher-N1/Saddle Finisher-N2 The height sensor (PS1) is faulty. The communication between the height sensor and the finisher controller PCB is prevented for 0.1 sec or more. |
E712 | Description: There is a fault in the communication between the ADF and the reader unit. DADF-K1 There is a fault in data communication. The ADF controller or the reader controller PCB is faulty. The connector between the reader unit an the ADF has poor |
E537 | Description: There is a fault in front alignment. Finisher-M1 The front alignment motor (M3) or the front aligning plate home position sensor (S6) is faulty. An excess load is imposed on the front aligning plate. The aligning plate fails to reach the al |
E002-0002 | Description: The rise in temperature of the fixing unit is inadequate. The output of the non-contact thermistor does not reach 60°C within 240 sec after it has reached 40°C. |
E606-0002 | Description: The hard disk is faulty. A reading error is detected when the HD is booted from BOOTROM. |
E504-0002 | Description: There is a fault in stack size detection. Finisher-N1/Saddle Finisher-N2 The height sensor (PS1) is faulty. The communication between the height sensor and the finisher controller PCB is prevented for 0.1 sec or more. |
E712 | Description: There is a fault in the communication between the ADF and the reader unit. DADF-K1 There is a fault in data communication. The ADF controller or the reader controller PCB is faulty. The connector between the reader unit an the ADF has poor |
E537 | Description: There is a fault in front alignment. Finisher-M1 The front alignment motor (M3) or the front aligning plate home position sensor (S6) is faulty. An excess load is imposed on the front aligning plate. The aligning plate fails to reach the al |