These results are ranked by popularity.
Error | |
---|---|
E067-0102 | Description: High voltage-related error (Primary transfer) The two detected currents of primary transfer ATVC are both the threshold or less. |
E5F2-8002 | Description: Saddle guide error The HP sensor fails to be OFF after the guide motor is driven for 1 sec. |
E015-0000 | Description: Error in the registration/multifeeder motor Indicates that the signal indicates the motor rotates with the target speed is not sent to the port after passing more than 3 sec from the startup of the motor. |
E540-8003 | Description: Stack tray up/down error Finisher-Z1 Encoder lock within 200ms fails to reach 10pulse during paper surface detection. |
E531-8002 | Description: Staple error The HP sensor fails to be ON after the staple motor rotates for a specific period of time. |
The most common error codes.
Error | |
---|---|
E067-0102 | Description: High voltage-related error (Primary transfer) The two detected currents of primary transfer ATVC are both the threshold or less. |
E5F2-8002 | Description: Saddle guide error The HP sensor fails to be OFF after the guide motor is driven for 1 sec. |
E015-0000 | Description: Error in the registration/multifeeder motor Indicates that the signal indicates the motor rotates with the target speed is not sent to the port after passing more than 3 sec from the startup of the motor. |
E540-8003 | Description: Stack tray up/down error Finisher-Z1 Encoder lock within 200ms fails to reach 10pulse during paper surface detection. |
E531-8002 | Description: Staple error The HP sensor fails to be ON after the staple motor rotates for a specific period of time. |
E067-0102 | Description: High voltage-related error (Primary transfer) The two detected currents of primary transfer ATVC are both the threshold or less. |
E5F2-8002 | Description: Saddle guide error The HP sensor fails to be OFF after the guide motor is driven for 1 sec. |
E015-0000 | Description: Error in the registration/multifeeder motor Indicates that the signal indicates the motor rotates with the target speed is not sent to the port after passing more than 3 sec from the startup of the motor. |
E540-8003 | Description: Stack tray up/down error Finisher-Z1 Encoder lock within 200ms fails to reach 10pulse during paper surface detection. |
E531-8002 | Description: Staple error The HP sensor fails to be ON after the staple motor rotates for a specific period of time. |