These results are ranked by popularity.
Error | |
---|---|
E067-0000 | Description: There is an error in the high-voltage output. An error is detected in two or more of the following at the same time: the primary high voltage, pre-transfer high voltage, transfer high voltage, and separation high voltage. Or, an error (leak |
E745 | Description: There is a fault on the TokenRing board |
E602 | Description: There is an error on the hard disk. |
E003-0000 | Description: The fixing temperature is too low after a standby state. The reading of the main thermistor is 70 deg C or lower for 2 sec or more after it has reached 100 deg C. |
E712-0000 | Description: Communication error with the ADF The communication IC (IPC) on the ADF controller PCB goes out of order. |
The most common error codes.
Error | |
---|---|
E067-0000 | Description: There is an error in the high-voltage output. An error is detected in two or more of the following at the same time: the primary high voltage, pre-transfer high voltage, transfer high voltage, and separation high voltage. Or, an error (leak |
E745 | Description: There is a fault on the TokenRing board |
E602 | Description: There is an error on the hard disk. |
E003-0000 | Description: The fixing temperature is too low after a standby state. The reading of the main thermistor is 70 deg C or lower for 2 sec or more after it has reached 100 deg C. |
E712-0000 | Description: Communication error with the ADF The communication IC (IPC) on the ADF controller PCB goes out of order. |
E067-0000 | Description: There is an error in the high-voltage output. An error is detected in two or more of the following at the same time: the primary high voltage, pre-transfer high voltage, transfer high voltage, and separation high voltage. Or, an error (leak |
E745 | Description: There is a fault on the TokenRing board |
E602 | Description: There is an error on the hard disk. |
E003-0000 | Description: The fixing temperature is too low after a standby state. The reading of the main thermistor is 70 deg C or lower for 2 sec or more after it has reached 100 deg C. |
E712-0000 | Description: Communication error with the ADF The communication IC (IPC) on the ADF controller PCB goes out of order. |