These results are ranked by popularity.
Error | |
---|---|
E197-0001 | Description: There is an error in communication between the DC controller PCB and the video PCB/an error in communication of the DC controller PCB. An error in the communication with the laser driver module of the DC controller PCB has occurred. |
E004-0106 | Description: The IH power supply is faulty/the IH control mechanism is faulty. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) The IH input voltage is too low. |
E732-0001 | Description: Error in reader communication There is a communication error between the reader and main controller (DDI-S communication error), or between the reader and the charger unit. |
E5F4-0002 | Description: There is a saddle rear stapler error. The stitching home position sensor does not go off even when the stitching motor (rear) has been driven in normal direction for 0.5 sec or more. stitching motor (rear, M6S), stitching home position sens |
E540-8006 | Description: There is an upper tray ascent/decent error. (finisher) The lock detection signal does not turn ON when the tray 1 shift motor has been driven for 1 second. |
The most common error codes.
Error | |
---|---|
E197-0001 | Description: There is an error in communication between the DC controller PCB and the video PCB/an error in communication of the DC controller PCB. An error in the communication with the laser driver module of the DC controller PCB has occurred. |
E004-0106 | Description: The IH power supply is faulty/the IH control mechanism is faulty. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) The IH input voltage is too low. |
E732-0001 | Description: Error in reader communication There is a communication error between the reader and main controller (DDI-S communication error), or between the reader and the charger unit. |
E5F4-0002 | Description: There is a saddle rear stapler error. The stitching home position sensor does not go off even when the stitching motor (rear) has been driven in normal direction for 0.5 sec or more. stitching motor (rear, M6S), stitching home position sens |
E540-8006 | Description: There is an upper tray ascent/decent error. (finisher) The lock detection signal does not turn ON when the tray 1 shift motor has been driven for 1 second. |
E197-0001 | Description: There is an error in communication between the DC controller PCB and the video PCB/an error in communication of the DC controller PCB. An error in the communication with the laser driver module of the DC controller PCB has occurred. |
E004-0106 | Description: The IH power supply is faulty/the IH control mechanism is faulty. After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR) The IH input voltage is too low. |
E732-0001 | Description: Error in reader communication There is a communication error between the reader and main controller (DDI-S communication error), or between the reader and the charger unit. |
E5F4-0002 | Description: There is a saddle rear stapler error. The stitching home position sensor does not go off even when the stitching motor (rear) has been driven in normal direction for 0.5 sec or more. stitching motor (rear, M6S), stitching home position sens |
E540-8006 | Description: There is an upper tray ascent/decent error. (finisher) The lock detection signal does not turn ON when the tray 1 shift motor has been driven for 1 second. |