These results are ranked by popularity.
Error | |
---|---|
E590-0001 | Description: Punch motor error The punching home position is not detected even when the puncher motor has been driven for 20 msec. |
E530-8002 | Description: Rear alignment error (Finisher-S1) The home position sensor does not go off within 1000 msec after the start of operation when the rear aligning plate is shifted from home position. |
E748-1001 | Description: There is a mismatch between controller board and SDRAM size. There is a mismatch between the control board and the SDRAM. |
E227-0003 | Description: The reader unit power supply is faulty. At the end of a job, the 24-V port is off. |
E716-0000 | Description: There is an error in the communication with the pedestal. After the presence of a pedestal has been detected, the communication fails to be normal for 5 sec |
The most common error codes.
Error | |
---|---|
E590-0001 | Description: Punch motor error The punching home position is not detected even when the puncher motor has been driven for 20 msec. |
E530-8002 | Description: Rear alignment error (Finisher-S1) The home position sensor does not go off within 1000 msec after the start of operation when the rear aligning plate is shifted from home position. |
E748-1001 | Description: There is a mismatch between controller board and SDRAM size. There is a mismatch between the control board and the SDRAM. |
E227-0003 | Description: The reader unit power supply is faulty. At the end of a job, the 24-V port is off. |
E716-0000 | Description: There is an error in the communication with the pedestal. After the presence of a pedestal has been detected, the communication fails to be normal for 5 sec |
E590-0001 | Description: Punch motor error The punching home position is not detected even when the puncher motor has been driven for 20 msec. |
E530-8002 | Description: Rear alignment error (Finisher-S1) The home position sensor does not go off within 1000 msec after the start of operation when the rear aligning plate is shifted from home position. |
E748-1001 | Description: There is a mismatch between controller board and SDRAM size. There is a mismatch between the control board and the SDRAM. |
E227-0003 | Description: The reader unit power supply is faulty. At the end of a job, the 24-V port is off. |
E716-0000 | Description: There is an error in the communication with the pedestal. After the presence of a pedestal has been detected, the communication fails to be normal for 5 sec |