These results are ranked by popularity.
Error | |
---|---|
E531-8002 | Description: Stapler Motor (M10) error The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec. |
E003-0000 | Description: Low fixing temperature detection after standby The reading of the main thermistor is less than 140 deg C continuously for 400 msec or more. |
E575-0001 | Description: Gripper Unit Move Motor (M2) error The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds. |
E025-0001 | Description: Failure of the Bottle Motor (M6) The bottle motor (M6) is unlocked when it goes on for 12 consecutive times at 0.1 sec. intervals. * Error occurs after the delivery if a paper in passage exists. |
E240-0001 | Description: Error in controller communication The serial communication error such as parity error or overrun error is detected while printing. |
The most common error codes.
Error | |
---|---|
E531-8002 | Description: Stapler Motor (M10) error The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec. |
E003-0000 | Description: Low fixing temperature detection after standby The reading of the main thermistor is less than 140 deg C continuously for 400 msec or more. |
E575-0001 | Description: Gripper Unit Move Motor (M2) error The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds. |
E025-0001 | Description: Failure of the Bottle Motor (M6) The bottle motor (M6) is unlocked when it goes on for 12 consecutive times at 0.1 sec. intervals. * Error occurs after the delivery if a paper in passage exists. |
E240-0001 | Description: Error in controller communication The serial communication error such as parity error or overrun error is detected while printing. |
E531-8002 | Description: Stapler Motor (M10) error The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec. |
E003-0000 | Description: Low fixing temperature detection after standby The reading of the main thermistor is less than 140 deg C continuously for 400 msec or more. |
E575-0001 | Description: Gripper Unit Move Motor (M2) error The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds. |
E025-0001 | Description: Failure of the Bottle Motor (M6) The bottle motor (M6) is unlocked when it goes on for 12 consecutive times at 0.1 sec. intervals. * Error occurs after the delivery if a paper in passage exists. |
E240-0001 | Description: Error in controller communication The serial communication error such as parity error or overrun error is detected while printing. |