These results are ranked by popularity.
Error | |
---|---|
E110-0003 | Description: Failure of the Scanner Motor (M21) The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed |
E571-0002 | Description: Gripper Open/Close Motor (M7) error The gripper unit does not return to the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.15 seconds. |
E354-0000 | Description: Mismatched serial number for the SOFT-ID PCB |
E736-0000 | Description: Erroneous communication between CCU and controller. |
E014-0001 | Description: Unstable rotation of the Fixing Motor (M2) Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. |
The most common error codes.
Error | |
---|---|
E110-0003 | Description: Failure of the Scanner Motor (M21) The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed |
E571-0002 | Description: Gripper Open/Close Motor (M7) error The gripper unit does not return to the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.15 seconds. |
E354-0000 | Description: Mismatched serial number for the SOFT-ID PCB |
E736-0000 | Description: Erroneous communication between CCU and controller. |
E014-0001 | Description: Unstable rotation of the Fixing Motor (M2) Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. |
E110-0003 | Description: Failure of the Scanner Motor (M21) The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed |
E571-0002 | Description: Gripper Open/Close Motor (M7) error The gripper unit does not return to the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.15 seconds. |
E354-0000 | Description: Mismatched serial number for the SOFT-ID PCB |
E736-0000 | Description: Erroneous communication between CCU and controller. |
E014-0001 | Description: Unstable rotation of the Fixing Motor (M2) Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. |