These results are ranked by popularity.
| Error | |
|---|---|
| E531-0002 | Description: - Staple unit failure - Staple HP sensor failure - Finisher controller PCB failure The staple home position had been left once, but it was not reached again when 400 ms have lapsed since start of staple operation. In addition, the staple h |
| E584-0001 | Description: Shutter drive motor or finisher controller PCB failure - Shutter open detection sensor failure - Shutter clutch failure The shutter open sensor did not turn on when 1000 ms have lapsed since the shutter unit had performed open operation, r |
| E808-0000 | Description: Fixing drive circuit failure - The heater does not turn on. - A fixing drive motor failure was detected. |
| E019-0002 | Description: Waster toner full detection sensor is faulty. The waste toner full state was detected continuously for five or more seconds while the main motor was turning. |
| E540-0001 | Description: Standard tray shift motor or finisher controller PCB failure - Standard tray HP sensor failure - Standard tray clock sensor failure - Standard tray shift motor load failure The standard tray was moved but the paper surface was not detected |
The most common error codes.
| Error | |
|---|---|
| E531-0002 | Description: - Staple unit failure - Staple HP sensor failure - Finisher controller PCB failure The staple home position had been left once, but it was not reached again when 400 ms have lapsed since start of staple operation. In addition, the staple h |
| E584-0001 | Description: Shutter drive motor or finisher controller PCB failure - Shutter open detection sensor failure - Shutter clutch failure The shutter open sensor did not turn on when 1000 ms have lapsed since the shutter unit had performed open operation, r |
| E808-0000 | Description: Fixing drive circuit failure - The heater does not turn on. - A fixing drive motor failure was detected. |
| E019-0002 | Description: Waster toner full detection sensor is faulty. The waste toner full state was detected continuously for five or more seconds while the main motor was turning. |
| E540-0001 | Description: Standard tray shift motor or finisher controller PCB failure - Standard tray HP sensor failure - Standard tray clock sensor failure - Standard tray shift motor load failure The standard tray was moved but the paper surface was not detected |
| E531-0002 | Description: - Staple unit failure - Staple HP sensor failure - Finisher controller PCB failure The staple home position had been left once, but it was not reached again when 400 ms have lapsed since start of staple operation. In addition, the staple h |
| E584-0001 | Description: Shutter drive motor or finisher controller PCB failure - Shutter open detection sensor failure - Shutter clutch failure The shutter open sensor did not turn on when 1000 ms have lapsed since the shutter unit had performed open operation, r |
| E808-0000 | Description: Fixing drive circuit failure - The heater does not turn on. - A fixing drive motor failure was detected. |
| E019-0002 | Description: Waster toner full detection sensor is faulty. The waste toner full state was detected continuously for five or more seconds while the main motor was turning. |
| E540-0001 | Description: Standard tray shift motor or finisher controller PCB failure - Standard tray HP sensor failure - Standard tray clock sensor failure - Standard tray shift motor load failure The standard tray was moved but the paper surface was not detected |
