These results are ranked by popularity.
Error | |
---|---|
E078-0000 | Description: Error in primary transfer estrangement unit Primary transfer estrangement unit does not function properly. |
E248-0003 | Description: EEPROM access error Error in EEPROM reading after writing |
E840-0000 | Description: Error in pressure release mechanism Although passing 2.5 sec from the start of HP control, HP (pressure condition) cannot be controlled. |
E003-0001 | Description: Error in abnormally low temperature of fixing assembly The status where the detected temperature of the sub thermistor is less than 100 deg C (approx. 0.38V equivalent) is detected 0.5 continuous sec or more after energization of the heater |
E012-0009 | Description: Error in activation of motor Bk After the black drum motor speed detection signal became the specified value of the cycle, it exceeds the specified cycle for 2 continuous sec or more. |
The most common error codes.
Error | |
---|---|
E078-0000 | Description: Error in primary transfer estrangement unit Primary transfer estrangement unit does not function properly. |
E248-0003 | Description: EEPROM access error Error in EEPROM reading after writing |
E840-0000 | Description: Error in pressure release mechanism Although passing 2.5 sec from the start of HP control, HP (pressure condition) cannot be controlled. |
E003-0001 | Description: Error in abnormally low temperature of fixing assembly The status where the detected temperature of the sub thermistor is less than 100 deg C (approx. 0.38V equivalent) is detected 0.5 continuous sec or more after energization of the heater |
E012-0009 | Description: Error in activation of motor Bk After the black drum motor speed detection signal became the specified value of the cycle, it exceeds the specified cycle for 2 continuous sec or more. |
E078-0000 | Description: Error in primary transfer estrangement unit Primary transfer estrangement unit does not function properly. |
E248-0003 | Description: EEPROM access error Error in EEPROM reading after writing |
E840-0000 | Description: Error in pressure release mechanism Although passing 2.5 sec from the start of HP control, HP (pressure condition) cannot be controlled. |
E003-0001 | Description: Error in abnormally low temperature of fixing assembly The status where the detected temperature of the sub thermistor is less than 100 deg C (approx. 0.38V equivalent) is detected 0.5 continuous sec or more after energization of the heater |
E012-0009 | Description: Error in activation of motor Bk After the black drum motor speed detection signal became the specified value of the cycle, it exceeds the specified cycle for 2 continuous sec or more. |